Rane Sixty-One Sixty-One Mixer Manual for Serato DJ - Page 11
Sixty-One Connections
View all Rane Sixty-One manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
OWNER'S MANUAL Sixty-One Connections Power Supply This mixer features an internal universal switching power supply that operates on any AC mains 100 to 240 VAC, 50 or 60 Hz (most places in the world). The universal supply is a major plus for the traveling DJ, who only needs the right IEC line cord, available from a local electronics store. Though this mixer has turn on/off muting, it's smart to leave the power unplugged until everything else is connected. Analog Inputs Four Phono / CD inputs are provided by RCA jacks. These may be set for PH or CD using rear panel slide switches. Analog inputs 1 and 2 are used by the DECK 1 controls. Analog inputs 3 and 4 are used by the DECK 2 controls. Analog input 1 or 2 may be selected in Serato DJ software (Audio tab in the Setup screen) as the Digital Vinyl Simulation (DVS) signal for the Left Virtual Deck or for recording on USB stereo pair 5-6. Analog input 3 or 4 may be selected in software as the DVS signal for the Right Virtual Deck or for recording on USB stereo pair 7-8. Set any unused inputs to CD. Connect your turntable ground wires to the ground posts provided on the rear panel when using PH inputs. One stereo Session Input is available on a pair of RCA jacks. This input may connect two mixers together, or as a general purpose line-level auxiliary input. The Mic Input will accept an XLR 3-pin plug, a balanced ¼˝ TRS (tip-ring-sleeve) plug or an unbalanced ¼˝ TS (tip-sleeve) plug. This input may be set for Microphone or Line level using the Mic / Line switch on the rear panel. Set this to LINE when connecting a wireless receiver. A stereo FlexFx Loop Return input is from a pair of unbalanced ¼˝ TS jacks. These inputs are automatically configured for mono when only one cable is connected to the Left or Right Return input. The FlexFx Return input is normally used in conjunction with the FlexFx Send output to connect an outboard analog effects processor. Analog Outputs There are four stereo analog outputs on the mixer: • Main Out is on a pair of balanced ¼˝ TRS (tip-ring-sleeve) jacks. • Session Out is on a pair of unbalanced RCA jacks. • FlexFx Loop Send output is on a pair of unbalanced ¼˝ inch TS (tip-sleeve) jacks. For a mono FlexFx Send, use the Left output. The FlexFx Send output is normally used in conjunction with the FlexFx Loop Return input to connect outboard effects. • Headphones output is available on both ¼˝ and 3.5 mm jacks. The Main and Session outputs come from the same "Main Mix" signal. Main and Session outputs each have their own Level control. Because these signals are identical, you may use either of these outputs as the "Main" output if the other cable type is required for system connection. That said, Rane recommends ¼˝ TRS (tip-ring-sleeve) cables for the strongest signal and rejection of hum and noise. If your cable to the amplifiers are less than 10 feet (3 meters), you can often get away with an unbalanced cable. See the RaneNote "Sound System Interconnection" at rane.com for cable wiring recommendations. 100-240V 50/60 Hz 15 WATTS USB MAIN OUT SESSION OUT IN PHONO MADE IN U.S.A. RANE CORP. ACN 001 345 482 GROUNDS 4 3 2 1 PH CD PH CD PH CD PH CD MIC LINE FLEXFX LOOP ANALOG INPUT SELECT MIC INPUT 4 3 2 1 SIXTY-ONE 11