Rane SM26S Operation Manual - Page 4

Operating Instructions Since numerous applications exist for the SM26S, no single set of operational procedures control its use. The SM26S Swiss Army Mixer RaneNote (included) explores the many configurations of the SM26S in depth, and you should peruse it for applications information. Internal Jumper Options There exist within the SM26S some signal routing options, requiring removal of the top cover to move some jumpers. This must only be done with the power off by qualified service personnel. If an SM26S needs to have an additional set of independent outputs, as in a 2x4 stereo distribution amplifier (see Swiss Army Mixer, Figure 10), the LEFT and RIGHT MIX OUTPUTS can be used in addition to the 6 MONO OUTS. Normally, the LEFT and RIGHT MIX OUTPUTS produce the sum mix of all 6 LEVEL and PAN controls. To break any channel away from the Mix Output bus, internal jumpers have been provided. These are located behind the MIX/PAN controls for each channel. J3 connects MONO OUT 1 to the mix bus. J6 connects MONO OUT 2, J9 connects MONO OUT 3, and so on - see the board layout. SHIP POSITION: SEND CHANNEL OUTPUT TO THE MIX BUS CHANGE JUMPER TO DISCONNECT AND ONLY ROUTE TO THE MONO OUT ©Rane Corporation 10802 47th Ave. W., Mukilteo WA 98275-5000 USA TEL 425-355-6000 FAX 425-347-7757 WEB rane.com Manual-4