Rane AC 23S Operation Manual - Page 8
Rear Panel: Stereo 3-way Connections - manual
View all Rane AC 23S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
REAR PANEL: STEREO 3-WAY CONNECTIONS 2 7 6 8 7 Stereo 3-way connection labels are in this row Right Input 1 Left Input 100-240 V COMMERCIAL AUDIO 50/60 Hz 7 WATTS EQUIPMENT 24TJ AC 23S MADE IN U.S.A. RANE CORP. PIN 2: POSITIVE PIN 3: NEGATIVE PIN 1: CHASSIS GND HIGH OUT 3W: MID OUT 2W: LOW 3W: LOW OUT 2W: OMIT R ACN 001 345 482 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. HIGH OUT 4W: OMIT 5W: HIGH MID OUT LOW OUT CHANNEL 2 IN MONO: OMIT STEREO 3W / 2W SET TO 5W CHANNEL 2 STEREO 3W 2W STEREO CHANNEL 1 MONO STEREO 4W 5W 3W 2W MONO: SET SWITCHES AS SHOWN HIGH OUT 3W: MID OUT 3W: LOW OUT 2W: LOW 2W: OMIT MONO: OMIT MID OUT SUB OUT CHANNEL 1 IN MONO 4W / 5W IN 9 345 345 High Amp High Amp Mid Amp Mid Amp Low Amp Low Amp Observe the labels above the Inputs and Outputs for Stereo operation. 1 CHANNEL 1 INPUT: Plug the left output of the mixer, equalizer or other source here. Pin 2 is "hot" per AES standards. 2 CHANNEL 2 INPUT: Plug the right output of the mixer, equalizer or other signal source to this Input. 3 HIGH OUTPUTS: Connect the CHANNEL 1 HIGH OUT to the left channel input of the high frequency amp, and the CHANNEL 2 HIGH OUT to the right channel input of the high frequency amp. 4 MID OUTPUTS: Connect the CHANNEL 1 MID OUT to the left channel of the mid frequency amp, and the CHANNEL 2 MID OUT to the right channel of the mid frequency amp. 5 LOW OUTPUTS: Connect the CHANNEL 1 and 2 LOW OUTS to the left and right channels of the low frequency amplifier, respectively. If you need a summed Mono Low Ouput, see 'Monoing the Low Outputs' on page Manual-15. 6 STEREO / MONO switch: Set this to the STEREO (out) position. 7 STEREO 2‑Way / 3‑Way switches: Set both Channels to the 3-Way position. 8 MONO 4‑Way / 5‑Way switch: Set this switch to the 5-Way position for stereo operation. 9 Universal Voltage Input: via a miniature IEC 60320 C6 appliance inlet. This mates with an IEC 60320 C5 line cord (USA domestic). Do not lift the ground connection! Manual-5