Rane AC 23S Operation Manual - Page 10
Rear Panel: Mono 4-way And Mono 5-way Connections
View all Rane AC 23S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
REAR PANEL: MONO 4-WAY AND MONO 5-WAY CONNECTIONS Mono 4-way and 5-way connection labels are in this row 8 79 8 1 Input 100-240 V COMMERCIAL AUDIO 50/60 Hz 7 WATTS EQUIPMENT 24TJ AC 23S MADE IN U.S.A. RANE CORP. PIN 2: POSITIVE PIN 3: NEGATIVE PIN 1: CHASSIS GND HIGH OUT 3W: MID OUT 2W: LOW 3W: LOW OUT 2W: OMIT R ACN 001 345 482 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. HIGH OUT 4W: OMIT 5W: HIGH MID OUT LOW OUT CHANNEL 2 IN MONO: OMIT STEREO 3W / 2W SET TO 5W CHANNEL 2 STEREO 3W 2W STEREO MONO CHANNEL 1 STEREO 4W 5W 3W 2W MONO: SET SWITCHES AS SHOWN HIGH OUT 3W: MID OUT 3W: LOW OUT 2W: LOW 2W: OMIT MONO: OMIT MID OUT SUB OUT CHANNEL 1 IN MONO 4W / 5W IN 0 653 42 High Amp Mid Amp Low Amp This output is not used in a 4-way mono con guration. High-Mid Amp Sub Amp Observe the labels below the Inputs and Outputs for Mono operation. 1 MONO INPUT: Connect the output from your mixer or other signal source only to the MONO 4W / 5W INPUT for Mono operation; do not use the Channel 2 Input. Pin 2 is "hot" per AES standards. 2 SUBWOOFER OUTPUT: Connect the SUB OUT to the input of the subwoofer (or bass bin) amplifier. 3 LOW OUTPUT: Connect the LOW OUT to the input of the low frequency (mid-bass) amp. 4 MID OUTPUT: Connect the MID OUT to the input of the mid frequency amplifier. 5 HlGH‑MID OUTPUT (FOR MONO 5‑WAY ONLY): Use this Output only for Mono 5-Way applications. Connect the HIGH-MID OUT to the input of the high-mid frequency amplifier. Do not use this Output when using the AC 23S as a Mono 4-Way Crossover. In 4-Way the AC 23S internally bypasses the High-Mid section and defeats all front panel High-Mid Controls. 6 HIGH OUTPUT: Connect the HIGH OUT to the input of the high frequency (tweeter) amp. 7 STEREO / MONO switch: Push this to the MONO (in) position. 8 STEREO 2‑Way / 3‑Way switches: For Mono 4-or 5-Way, slide these switches to the 3-Way position. 9 MONO 4‑Way / 5‑Way switch: set as required. In 4-Way, the HIGH-MID OUTPUT duplicates the MID OUTPUT frequencies with a different low pass setting as determined by the HIGH-MID / HIGH FREQUENCY control, and is not normally recommended for use since the tweeter crossover point will be inaccurate. 0 Universal Voltage Input: via a miniature IEC 60320 C6 appliance inlet. This mates with an IEC 60320 C5 line cord (USA domestic). Do not lift the ground connection! If your 4‑way system needs a higher range of 190 Hz‑7 kHz for LOW / MID, see the configuration on the following page. Manual-7