Panasonic UF 885 Laser Facsimile - Page 38

Customizing Your Machine No. Parameter Setting Number 24 PRINT REDUCTION 1 *2 25 REDUCTION RATIO 70 ---- 100 26 POLLING PASSWORD 27 POLLED FILE SAVE *1 2 28 STAMP AT MEM. XMT 1 *2 31 INCOMPLETE FILE *1 SAVE 2 32 COPY REDUCTION 1 *2 33 XMT REDUCTION 1 *2 34 ENERGY SAVER MODE 1 Setting Fixed Auto 70% ---100% (----) Invalid Valid Invalid Valid Invalid Valid Manual Auto Invalid Valid Off Comments Selecting print reduction mode. Fixed: Reduce received document according to setting of Parameter No. 25. Auto: Reduce received document according to the length of received documents. Selecting fixed print reduction ratio from 70% to 100%. This parameter functions only when fixed print reduction is selected on Fax Parameter No. 24. Setting a 4-digit password for secured polling. (See page 68) Selecting whether the machine retains the polled document in memory even after the document is polled once. Selecting whether the machine stamps the original documents when storing the documents into memory. (depending on the Stamp setting on the Control Panel) Selecting whether the machine retains the document in memory if the document is not successfully transmitted. Selecting whether the machine performs the copy reduction ratio automatically or manually. Manual : The machine will prompt you for the Zoom ratio (100% to 70%) when making copies. Auto : The machine will automatically determine the reduction ratio according to the length of the original document. Selecting whether the machine performs reduction when the transmitting document is wider than the recording paper used at the receiving machine. To reduce the power consumption in standby, select either EnergySaver or Sleep mode and specify the Delay Time (1 to 120 minutes) for the machine to enter into the selected mode. The Delay Timer setting is only available in the Energy-Saver or Sleep Modes. Off : The unit will remain in standby mode and consume more energy than when in Energy- Saver or Sleep modes. 2 Energy-Saver Energy-Saver Mode: Saves energy by consuming less power than when in standby mode by turning off the fuser unit after the specified time. Sleep Mode: This is the lowest power state that the machine enters after the specified time without actually turning off. (Sleep Mode is *3 Sleep not available when the optional Parallel Port Interface Kit, PDL Printer Driver Kit or G3 Communication Port Kit is installed) Continued on the next page. 36