Panasonic UF-780 Panafax - Page 38

Customizing Your Machine Fax Parameter Table 38 No. Parameter 34 ENERGY SAVER MODE Setting Number 1 2 *3 35 DAYLIGHT TIME 1 *2 36 RING PATTERN *1 DETECT (DRD) (See Note 2) 2 37 RCV TO MEMORY 38 ACCESS CODE 39 PIN CODE ACCESS *1 2 3 42 CONF. POLLED FILE *1 SAVE 2 43 PASSWORD-XMT *1 2 44 PASSWORD-RCV *1 2 46 SELECT RCV *1 2 47 REMOTE RECEPTION 1 *2 Setting Comments Off EnergySaver Sleep Invalid Valid Invalid Valid (----) (----) None Suffix Prefix Invalid Valid Off On Off On Invalid Valid Invalid Valid To reduce the power consumption in standby, select either Energy-Saver or Sleep mode and specify the Delay Time (1 to 120 minutes) for the machine to enter into the selected mode. The Delay Timer setting is only available in the Energy- Saver or Sleep Modes. Off : The unit will remain in standby mode and consume more energy than when in Energy-Saver or Sleep modes. Energy-Saver Mode : Saves energy by consuming less power than when in standby mode by turning off the fuser unit after the specified time. Sleep Mode : This is the lowest power state that the machine enters after the specified time without actually turning off. Selecting whether the clock adjusts for Daylight Saving Time automatically. The built-in clock will advance 1 hour at 2:00 am on the first Sunday in April and fallback 1 hour at 2:00 am on the last Sunday in October. All ring patterns. Select a ring pattern for automatic answering. 1: A Standard ring pattern. 2: B Double ring pattern. 3: C Triple ring pattern (Short-Short-Long). 4: D All other triple ring patterns, except the type C described above. Enter a 4-digit password used to print out the received document in memory by using F8-5 (RCV TO MEMORY). When F8-5 is set to On, this parameter will not be shown on the LCD display. (See page 92) Enter a 4-digit Access Code to secure the machine from unauthorized use. (See page 90) Selecting the access method (Prefix or Suffix) to dial a number with PIN Code. (See page 97) Selecting whether the machine saves the confidential polled file even after the file is polled once. Setting a 4-digit XMT-Password and selecting whether the machine performs and checks the XMT-Password of the receiving station when transmitting. (See page 102) Setting a 4-digit RCV-Password and selecting whether the machine performs and checks the RCV-Password of the transmitting station when receiving. (See page 103) Selecting whether the machine performs selective reception. (See page 100) Selecting whether or not the machine accepts remote reception command. (See page 63)