Panasonic AWRP400N AWPH400 User Guide - Page 11

AW-PH400 Parts and their function J Y connector [Y] This is the output connector for the camera's video signals. It is connected to the Y/VIDEO connector on the AW-RC400 cable compensation unit or monitor, etc. Use a BNC coaxial cable for the connecting cable. The AW-PB302 RGB card must be installed if the AW-E300, AW-E300A, AW-E600, AW-E800 or AW-E800A convertible camera is to be used. K 1394 connector [1394] This is used for the control of the convertible camera and pan/tilt head equipped with an IEEE1394 card such as the AW-PB310. Use an IEEE1394 cable for the connecting cable. L SDI connector [SDI] This is the output connector for the camera's video signals. When the AW-PB504 SDI card or other card is inserted in the convertible camera for use, SDI signals can be output. Use a BNC coaxial cable for the connecting cable. M G/L IN connector [G/L IN] This is the genlock signal input connector. It is connected to the G/L OUT connector on the AW-RC400 cable compensation unit or other unit. Use a BNC coaxial cable for the connecting cable. N PROMPTER IN connector [PROMPTER IN] The video signals for the prompter are input to this connector. Use a BNC coaxial cable for the connecting cable. O Pb connector [Pb] This is the output connector for the camera's video signals. It is connected to the Pb connector on the AW-RC400 cable compensation unit or monitor, etc. Use a BNC coaxial cable for the connecting cable. P Pr/C connector [Pr/C] This is the output connector for the camera's video signals. It is connected to the Pr/C connector on the AW-RC400 cable compensation unit or monitor, etc. Use a BNC coaxial cable for the connecting cable. Indoor Pan/Tilt Head AW-PH400 11