Netgear M4300-28G User Manual - Page 626
Dst L4, Range, port key, Other, Equal, Less Than, Greater Than, Not Equal, Start Port, End Port
View all Netgear M4300-28G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 626 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches The source IPv6 address argument must be in the form documented in RFC 2373 where the address is specified in hexadecimal using 16-bit values between colons. • Dst L4. The options are available only when protocol is set to TCP or UDP. Use the destination L4 port option to specify relevant matching conditions for L4 port numbers in the extended ACL rule. You can select either the Port radio button or the Range radio button: - If you select the Port radio button, you can either select port key from the menu or enter the port number yourself. • The destination IP TCP port names are bgp, domain, echo, ftp, ftpdata, http, smtp, snmp, Telnet, www, pop2, pop3. • The destination IP UDP port names are domain, echo, ntp, rip, snmp, tftp, time, who. Each of these values translates into its equivalent port number, which is used as both the start and end of the port range. Select Other from the menu to enter a port number. If you select Other from the menu but leave the field blank, it means any. The relevant matching conditions for L4 port numbers are as follows: • Equal. The IPv6 ACL rule matches only if the Layer 4 destination port number is equal to the specified port number or port key. • Less Than. The IPv6 ACL rule matches if the Layer 4 destination port number is less than the specified port number or port key. • Greater Than. The IPv6 ACL rule matches if the Layer 4 destination port number is greater than the specified port number or port key. • Not Equal. The IPv6 ACL rule matches only if the Layer 4 destination port number is not equal to the specified port number or port key. - If you select the Range radio button, the IPv6 ACL rule matches only if the Layer 4 destination port number is within the specified port range. The starting port, ending port, and all ports in between are a part of the Layer 4 port range. The Start Port and End Port fields identify the first and last ports that are part of the port range. They values can range from 0 to 65535. Select Other from the menu to enter port numbers. If you select Other from the menu but leave the fields blank, it means any. • IGMPv6 Type. If you specify the IGMPv6 type, the IPv6 ACL rule matches the specified IGMPv6 message type. Possible values are in the range 0 to 255. If this field is left empty, it means any. • ICMPv6. Select either the ICMP Type or ICMP Message radio button: - If you select the ICMP Type radio button, note the following: • The ICMP Type and ICMP Code fields are enabled only if the protocol is ICMPv6. Use these fields to specify a match condition for ICMPv6 packets: Manage Switch Security 626 User Manual