Netgear GSM4328PB User Manual - Page 81

M4300 Intelligent Edge Series Fully Managed Stackable Switches • Tunnel interface • Service port By default VLAN 1 is used as the source interface. 10. To specify the DNS server to which the switch sends DNS queries, do the following: a. In the DNS Server Address field in the DNS Server Configuration table, enter an IP address in standard IPv4 or IPv6 dot notation. b. Click the Add button. The server is added to the table. You can specify up to eight DNS servers. The precedence is set in the order that you add the servers. 11. To remove a DNS server from the DNS Server Configuration table, do the following: a. Select the check box for the server. b. Click the Delete button. Note: If you click the Delete button without selecting a DNS server, all the DNS servers are deleted from the table. 12. Click the Apply button. Your settings are saved. The following table displays DNS Server Configuration information. Table 25. DNS Server Configuration Field Serial No Preference Description The sequence number of the DNS server. Shows the preference of the DNS server. The preference is determined by the order in which they were entered. Add a Static Entry to the Local DNS Table You can manually map host names to IP addresses or to view dynamic DNS mappings. To add a static entry to the local DNS table: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. Configure System Information 81 User Manual