Netgear GSM4328PB User Manual - Page 440
Con PIM Settings, Con the Multicast PIM Global Settings
View all Netgear GSM4328PB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 440 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches The following table describes the nonconfigurable information that is displayed. Table 166. Multicast IGMP Proxy Membership Field Proxy Interface Group IP Source Hosts Last Reporter Up Time Expiry Time State Filter Mode Number of Sources Description The interface on which IGMP proxy is enabled. The IP multicast group address. This parameter shows source addresses that are members of this multicast address. The IP address of the source of the last membership report received for the IP multicast group address on the IGMP proxy interface. The time elapsed since this entry was created. This parameter shows expiry time interval against each source address that is a member of this multicast group. This is the amount of time after which the specified source entry is aged out. The state of the host entry. A host can be in one of the state. Non-member state - does not belong to the group on the interface. Delaying member state - host belongs to the group on the interface and report timer running. The report timer is used to send out the reports. Idle member state - host belongs to the group on the interface and no report timer running. The group filter mode (Include/Exclude/None) for the specified group on the IGMP proxy interface. The number of source hosts present in the selected multicast group. Configure PIM Settings You can configure PIM settings and view PIM statistics. Configure the Multicast PIM Global Settings Protocol-Independent Multicast (PIM) is a standard multicast routing protocol that provides scalable interdomain multicast routing across the Internet, independent of the mechanisms provided by any particular unicast routing protocol. To configure the PIM global settings: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. Configure Multicast Routing 440 User Manual