Mr. Coffee BVMC-ECMP1000 User Manual - Page 5

BEFORE USING YOUR APPLIANCE FOR THE FIRST TIME Step 1 - CLEAN THE APPLIANCE 1. Make sure unit is unplugged and the On/Off switch is in the Off position "O". 2. Remove stickers and labels from the unit. NOTE: REMOVE THE RED PLUG FOUND AT THE BASE OF THE WATER RESERVOIR. 3. Remove and wash the water reservoir, milk reservoir, porta-filter, 2 filters and measuring scoop in a mixture of mild detergent and water. Rinse each thoroughly and place back onto appliance. NOTE: Porta-filter and water reservoir are NOT dishwasher safe. Step 2 - PRIME THE UNIT (must be completed prior to first use) 1. Plug unit in and turn unit ON ("l") using the On/Off switch. 2. Fill water reservoir up to the "MAX" level with water and place back on unit. 3. Fill milk reservoir up to the "MAX" level with water and place back on unit. Be sure to firmly push the milk reservoir into place until Cappuccino and Latte buttons illuminate. 4. Place porta-filter in the unit ensuring it is properly locked. For more instructions, refer to the "Placing the Porta-Filter" section on page 11 of this manual. 5. Place a large cup under porta-filter. 6. Aim the tip of the frothed milk dispensing tube inside the cup. 7. Once all 3 lights on the control panel stop pulsing and remain illuminated, press the Espresso button " " and hold until the pump starts then release the button. Once the pump starts, let it run until the unit stops automatically or until you see water flow from porta-filter. To stop the process yourself, press the Espresso button " " again. 8. If you do not see water flow from porta-filter after unit stops automatically, repeat step 7 until you do. 9. Empty cup and place back under porta-filter. 10. Press the cappuccino button " " and hold until pump starts then release it. Once the pump starts, let it run until the unit stops automatically or until you see water flow from the frothed milk dispensing tube. To stop the process yourself, press the Cappuccino button " " again. 11. Once step 10 is complete, the 3 control panel lights will remain illuminated indicating that the unit is ready for use. 8 BVMC-ECMP1000_BVMC-ECMP1001_13ESM1.indd 9-10 HOW TO SELECT THE RIGHT CUP Please make sure to select your cup according to the following chart: BEVERAGE AMOUNT Espresso Single ( ) Double ( ) 1.25 oz 2.5 oz Cappuccino Latte Single ( ) Double ( ) Single ( ) Double ( ) 6 oz 10 oz 12 oz 15 oz NOTE: The total amount of the beverage can vary depending on the type of milk used and Froth Control Knob setting. SELECTING THE RIGHT COFFEE THE COFFEE The coffee should be freshly ground and dark roasted. You may want to try a French or Italian roast ground for espresso. Pre-ground coffee will only retain its flavor for 7 - 8 days, provided it is stored in an airtight container and in a cool, dark area. Do not store in a refrigerator or freezer. Whole beans are recommended to be ground just before use. Coffee beans stored in an airtight container will keep its flavor for up to 4 weeks. THE GRIND This is a vital step in the espresso making process if you are grinding your own coffee and takes practice. The coffee must be of a fine grind. • The correct grind should look like salt. • If the grind is too fine, the water will not flow through the coffee even under pressure. These grinds look like powder and feel like flour when rubbed between fingers. • If the grind is too coarse, the water flows through the coffee too fast, preventing a full-flavored extraction. Be sure to use a quality grinder for uniform consistency. A conical or burr mill grinder is recommended for a consistent and fine espresso grind. 9 9/30/13 2:33 PM