Metabo RSEV 19-125 RT Operating Instructions - Page 10

en ENGLISH Original instructions 1. Declaration of Conformity b) This power tool is not suitable for routing, polishing, sanding, working with roughing We declare under our sole responsibility: These concrete grinders, identified by type and serial number *1), comply with all relevant requirements of the directives *2) and standards *3). Technical file at *4) - see page 3. discs, wire brushes, parting grinder discs or flap discs. Using the power tool for tasks for which it was not designed may create a hazard and cause personal injury. c) Do not use accessories that are not specifically designed and recommended by the tool 2. Specified Use manufacturer. Just because an accessory can be attached to your power tool does not mean safe When fitted with original Metabo accessories, the machine is suitable for grinding and removing concrete, screed and coatings with diamond cup wheels. Do not use for abrasive cutting-off operations, roughing work, sanding, polishing or flap disc work. The machine must not be used with water. operation is guaranteed. d) The rated speed of the accessory must be at least equal to the maximum speed marked on the power tool. Accessories running faster than their rated speed can break and fly apart. e) The outside diameter and the thickness of your accessory must be within the capacity rating of your power tool. Incorrectly sized acces- Note: The ring brush may stick when thermoelastic materials are processed. sories cannot be adequately protected or controlled. The machine is suitable for commercial use in trade and industry. Always use a suitable dust extraction system: Connect a vacuum cleaner (M-class) to the extractor connection piece (12). f) The arbour size of flanges, diamond cup wheels or any other accessory must properly fit the spindle of the power tool. Accessories with arbour holes that do not match the mounting hardware of the power tool will rotate unevenly, vibrate excessively and may cause loss of control. The user bears sole responsibility for any damage caused by improper use. g) Do not use a damaged accessory. Before use, always check accessories for splinters or Generally accepted accident prevention regula- cracks and check grinding wheels for cracks or tions and the enclosed safety information must be signs of severe wear and tear. If a power tool or observed. accessory is dropped, inspect for damage or install an undamaged accessory. After 3. General safety instructions inspecting and installing an accessory, position yourself and bystanders away from the For your own protection and for the protection of your power tool, pay attention to all parts of the text that are marked with this symbol! WARNING - Reading the operating instructions will reduce the risk of injury. plane of the rotating accessory and run the power tool at maximum no-load speed for one minute. Damaged accessories will normally break apart during this test time. h) Wear personal protective equipment. Depending on the application, use a face shield, safety goggles or safety glasses. As WARNING Read all safety warnings and instructions. Failure to follow all safety warnings and instructions may result in electric shock, fire and/or serious injury. appropriate, wear a dust mask, hearing protectors, gloves and workshop apron capable of stopping small abrasive or workpiece fragments. The eye protection must be capable of stopping flying debris generated by various operations. Keep all safety instructions and information for future reference. Pass on your electrical tool only together with these documents. The dust mask or respirator must be capable of filtering particles generated by your operation. Prolonged exposure to high intensity noise may cause hearing loss. i) Keep bystanders a safe distance away from 4. Special Safety Instructions your work area. Anyone entering the work area must wear personal protective equipment. General safety instructions for grinding: Use Fragments of a workpiece or broken accessory may fly into the air and cause injury beyond the immediate area of operation. a) This power tool is designed for surface grinding. Refer to all safety warnings, instructions, illustrations and specifications provided with this power tool. Failure to follow all the instructions may result in electric shock, fire and/or 10 serious injury. j) Hold power tool by insulated gripping surfaces only, when performing an operation where the cutting accessory may contact hidden wiring or its own cord. A cutting accessory that comes in contact with a "live" wire may