Marantz PM7005 PM7005 Owner Manual - English - Page 18

. .. . . . Contents Connections Playback Connecting speakers NOTE 0 Disconnect this unit's power plug from the power outlet before connecting the speakers. 0 Connect so that the speaker cable core wires do not protrude from the speaker terminal. The protection circuit may be activated if the core wires touch the rear panel or if the + and - sides touch each other. ("Protection circuit" (v p. 47)) 0 Never touch the speaker terminals while the power cord is connected. Doing so could result in electric shock. 0 Use speakers with impedance of 4 - 8 Ω/ohms. o Connecting the speaker cables Carefully check the left (L) and right (R) channels and + (red) and (white) polarities on the speakers being connected to this unit, and be sure to connect the channels and polarities correctly. 1 Peel off about 3/8 inch (10 mm) of sheathing from the tip of the speaker cable, then either twist the core wire tightly or terminate it. Settings Tips Appendix 3 Insert the speaker cable's core wire to all the way into the speaker terminal. 4 Turn the speaker terminal clockwise to tighten it. Spade lug connector 2 Turn the speaker terminal counterclockwise to loosen it. When using a banana plug Tighten the speaker terminal firmly before inserting the banana plug. Front panel Rear panel Remote control 18 unit Index