LiftMaster CSW24UL Installation Manual - Page 20

AH battery

Get LiftMaster CSW24UL PDF manuals and user guides View all LiftMaster CSW24UL manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

INSTALLATION 33AH battery The batteries are charged in the circuit by the integrated transformer. The batteries are for battery backup or solar installation. The 33AH application requires the Solar Harness Kit (Model K94-37236) and an additional battery tray (Model K10-34758-2). 1. Locate the J15 plug on the control board and disconnect it. 2. Connect the white jumper from the Solar Harness Kit between the positive (+) terminal of one battery and the negative (-) terminal of the other battery. 3. Connect one end of the red (+) wire from the Solar Harness Kit to the red wire from the J15 plug as shown. Connect the other end of the red (+) wire to the positive (+) terminal on the battery as shown. 4. Connect one end of the black (-) wire from the Solar Harness Kit to the black wire from the J15 plug as shown. Connect the other end of the black (-) wire to the negative (-) terminal on the battery as shown. 5. Turn ON AC power to the operator. 6. Turn ON the AC power switch on the operator. 7. Reconnect the J15 plug to the control board. NOTE: You may see a small spark when plugging the J15 plug into the board. 20

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
20
33AH battery
The batteries are charged in the circuit by the integrated transformer. The batteries are for battery backup or solar installation. The 33AH application
requires the Solar Harness Kit (Model K94-37236) and an additional battery tray (Model K10-34758-2).
1.
Locate the J15 plug on the control board and disconnect it.
2.
Connect the white jumper from the Solar Harness Kit between the positive (+) terminal of one battery and the negative (-) terminal of the other battery.
3.
Connect one end of the red (+) wire from the Solar Harness Kit to the red wire from the J15 plug as shown. Connect the other end of the red (+) wire
to the positive (+) terminal on the battery as shown.
4.
Connect one end of the black (-) wire from the Solar Harness Kit to the black wire from the J15 plug as shown. Connect the other end of the black (-)
wire to the negative (-) terminal on the battery as shown.
5.
Turn ON AC power to the operator.
6.
Turn ON the AC power switch on the operator.
7.
Reconnect the J15 plug to the control board.
NOTE:
You may see a small spark when plugging the J15 plug into the board.
INSTALLATION