Kenwood VRS-6100 Instruction Manual - Page 35
In case of difficulty - problems
![]() |
View all Kenwood VRS-6100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
In case of difficulty Resetting the Microcomputer The microcomputer may malfunction (unit cannot be operated, or shows an erroneous display) if the power cord is unplugged while the power is ON, or due to some other external factor. If this happens, execute the following procedure to reset the microcomputer and return the unit to its normal operating condition. Unplug the power cord from the wall outlet, then plug it back in while holding down the POWER ON/STANDBY key. ÷ Please note that resetting the microcomputer will clear the contents of the memory and returns the unit to the state it was in when it left the factory. Amplifier Symptom No sound from the speakers. Remedy ÷ Connect them properly referring to "Connecting the speakers" ÷ If muting is ON, release it. ÷ If headphones are connected, disconnect them. ÷ Press the INPUT MODE key to select to full auto mode. @ ¢ ¢ 8 Sound is not output from the speaker, or their sound is very small. ÷ Connect them properly referring to "Connecting the speakers" ÷ See "Speaker settings" and check if the setting for all of the speakers is correct. ÷ Select a surround mode. ÷ Adjust the speaker levels using the test tone. @ * ) The standby indicator blinks and sound ÷ Speaker cords are short-circuited. Disconnect the power cord from the AC wall outlet, switch is not output. the receiver OFF, remove the short-circuiting and turn the receiver ON again. Audio cannot be recorded. ÷ Connect the equipment correctly by referring to "Connecting video components, audio components" and "Digital connections". 0! ÷ If it is the digital audio that you attempt to record, set up the unit correctly by referring to "Recording music in AUTO REC or MANUAL REC mode". ∞ A video source cannot be recorded ÷ Copy-guarded video software cannot be recorded. normally. When playing a digital source signal, the sound is cut off soon after it starts. ÷ There are many possible causes for this problem, depending on the type of player used. Switch the input mode to DIGITAL MANUAL during playback of the digital source, and restart the playback from the beginning. 8 Dolby Digital or DTS audio software cannot be played in multi-channel audio. ÷ Check if the digital output setting of the digital audio player is correct. Tuner Symptom Radio stations cannot be received. Remedy ÷ Connect an antenna properly. ÷ Set the broadcast band properly. ÷ Tune the frequency of the desired station. % § Interference. ÷ Install the outdoor antenna away from the road. ÷ Turn off the power to the appliance. ÷ Install the receiver farther away from the TV. A station which was preset cannot be received by pressing the corresponding numeric key. ÷ Preset a station with a receivable frequency. 35 EN
![](/manual_guide/products/kenwood-vrs6100-instruction-manual-304b55e/35.png)