Kenmore 000/12 Operating Instructions - Page 9

6) Selectthe desiredtan speedby pressingtheFAN button. NOTE: During hot days, the unit will cool the room most efficiently by setting the temperature at the lowest setting and the fan speed on high. Reducing the length of the exhaust duct, insulating the exhaust hose and window kit, and keeping direct sunlight to a minimum will also improve the cooling efficiency. Dehumidifier Mode 1) Install the exhaust hoses and window kit properly (see pages 6). 2) Plug the Power Cord into an electrical outlet. 3) Turn on the unit by pressing the POWER Button on the control panel. 4) Press the MODE button until the" (') " appears on the control panel display. NOTE: The unit operates at low fan speed during dehumidifier mode. The unit cools room slightly during the dehumidification. Keep the windows and doors closed to aid the effectiveness of the unit in removing the moisture from the room. o NOTE: The unit will not perform in dehumidifier mode when the room temperature is lower than 61 F. Fan Mode l) Plug the Power Cord into an electrical outlet. 2) Turn on the unit by pressing the POWER button on the control panel. 3) Press the MODE button until the" _!_ "icon appears on the control panel display. 4) Select the fan speed by pressing the FAN button. 5) To circulate more air, press the SWING button on the remote control. The louvers will oscillate in our exclusive WAVEFLO(R) pattern; back and forth and up and down, spreading more air throughout the room. NOTE: It is not necessary for the exhaust hoses and window kit to be installed to operate the unit in fan mode. Heatinq Mode 1) Plug the Power Cord into an electrical outlet. 2) Turn on the unit by pressing the POWER button on the control panel. 3) Press the MODE button until the" _':2_ "icon appears on the control panel display. 4) Press the Tor • buttons until the desiredoroOm temperature appears on the control panel display. The temperature ranges from 61°F - 88 F (16 C - 31 C). 5) Select the fan speed by pressing the FAN button. It is recommended to set the fan speed to low. NOTE: It is not necessary for the exhaust hoses and window kit to be installed to operate the unit in heating mode. Auto Mode 1) Install the exhaust hoses and window kit properly (see pages 6). 2) Plug the Power Cord into an electrical outlet. 3) Turn on the unit by pressing the POWER button on the control panel. 4) Press the MODE button until the" _/* "icon appears on the control panel display. Select the fan speed