Kenmore 000/12 Operating Instructions - Page 12

REMOTE CONTROL OPERATING INSTRUCTIONS 1) Power On and Off - Press the POWER (1/O) button once to manually turn the unit on. Press the Power button once more to turn the unit off. When you press the POWER button the upper right square on the remote control LCD Display will light up. When in Air Conditioner, Heating, and Auto mode, the selected temperature will appear on the remote control display. When the unit is in Fan mode and Dehumidifier mode you will see the "- -" icon instead of the set temperature. This shows that temperature selection is not available when the unit is in Fan or Dehumidifier mode. 2) Mode Selection - Press the MODE Button repeatedly to cycle between the different modes: Auto, Air Conditioner, Dehumidifier, Fan only, and Heater mode. The upper left square on the Remote control display will light up showing which mode is selected. In Air Conditioner mode the display will show "COOLING", in Heating mode the display will show "HEAT", in Dehumidifier mode the display will show "DRY", in Fan mode the display will show "FAN", and in Auto mode the display will show "AUTO". 3) Fan Speed - Press the FAN speed button to cycle through low, medium, and high fan speeds. The dis- play on the remote control will show LOW, MED, & HIGH under the "SPEED" label on the remote control LCD display. There is an additional auto speed setting that is enabled in only heating and cooling modes. This speed is next setting after low when pressing the FAN speed button on the remote control. The speeds will cycle through in this order: High, Medium, Low, Auto. Each change in speed will be associated with a "beep" sound from the unit. The remote control will not display "AUTO" under the speed label. Once Auto fan speed is selected the unit will beep and there will not be a fan speed displayed on the remote control. 4) Temperature Settinq - When the unit is in Air Conditioner or Heating mode you can select your desired temperature. Press the • or • to select your desired temperature setting. The temperature on the LCD display on the remote control will increase or decrease accordingly. Pressing the • and • buttons simultaneously will change the temperature select between °F and °C. 5) SWING - To turn on the exclusive WAVEFLO(R) oscillation, press the SWING button on the remote control. Once you press SWING, the louvers on the unit will oscillate up and down and back and forth. The bottom left square of the remote control display will show the "_--V' icon when WAVEFLO(R) oscillation (SW1NG) is selected. 6) TIMER - To program the timer, first press the T-ON button. Once T-ON is pressed the auto-on timer will blink in the bottom right rectangle of the remote control display. Press the MIN and HOUR buttons to change the clock to the desired time for the unit to automatically turn on. The minutes will increase by 10 with each press of the MIN button and the hours will increase by 1 with each press of the HOUR button. Press the T-OFF button and the remote control display will flash the desired auto-off timer. Press the MIN and HOUR buttons to change the clock to the desired time for the unit to automatically turn off. The timer is set when the auto-off time stops flashing and the words "ON" and "OFF" are displayed next to the time. 7) CLOCK - To set the clock on the remote control, hold down either the MIN or HOUR button until the displayed time flashes on the remote control display. Change the minutes by pressing the MIN button and change the hours by pressing the HOUR button. 12