Honeywell 4600RSF051CE User Guide - Page 33
Terminal Interfaces, Terminal ID
View all Honeywell 4600RSF051CE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
2 Terminal Interfaces Terminal ID If your interface is not covered by a Plug and Play barcode from Chapter 1, then refer to Supported Terminals on page 2-2 through page 2-3, and locate the Terminal ID number for your PC. Scan the Terminal ID barcode below, then scan the numeric barcode(s) from the Programming Chart inside the back cover of this manual to program the imager for your terminal ID. Scan Save to save your selection. For example, an IBM AT terminal has a Terminal ID of 003. You would scan the Terminal ID barcode, then 0, 0, 3 from the Programming Chart inside the back cover of this manual, then Save. If you make an error while scanning the digits (before scanning Save), scan the Discard code on the Programming Chart, scan the Terminal ID barcode, scan the digits, and the Save code again. Terminal ID Save Note: After scanning one of these codes, you must power cycle your computer. 2 - 1