HP R1.5kVA HP UPS R3000 User Guide - Page 23
Connecting devices to the UPS, Connecting the UPS cord retention clips, WARNING, CAUTION
View all HP R1.5kVA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
WARNING: To prevent injury from electric shock or damage to the equipment: • Plug the input line cord into a grounded (earthed) electrical outlet that is installed near the equipment and is easily accessible. • Do not disable the grounding plug on the input line cord. The grounding plug is an important safety feature. • Do not use extension cords. Connect the UPS to a grounded utility power outlet. When the UPS is plugged in, it automatically enters Standby mode and begins charging the batteries. Connecting devices to the UPS CAUTION: Do not plug laser printers into the UPS output receptacles. The instantaneous current drawn by this type of printer can overload the UPS. Before connecting devices, verify that the UPS will not overload by checking that the ratings of the devices do not exceed the UPS capacity. If the equipment rating is listed in amps, multiply the number of amps by the selected output voltage to determine the VA. After verifying that the UPS will not overload: (depending on your model) • Connect the device power cords to the output receptacles on the rear panel of the UPS. -or- • Connect devices to the output receptacles on the rear panel of the UPS using the jumper cords included with the UPS. To provide additional receptacles, plug a PDU into the PDU output receptacle. The PDU output receptacle is part of load segment 1 and can be turned off and on using power management software (on page 32). Connecting the UPS cord retention clips NOTE: UPS appearance might vary depending on the specific unit installed. Installation 23