HP Q3726A HP LaserJet 9040mfp/9050mfp - User Guide - Page 209
Manual Feed Prompt, Use Requested Tray
View all HP Q3726A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 209 highlights
Item Values Explanation SHOW ADDRESS=OFF AUTO OFF Sets whether or not the MFP IP address will be shown with the Ready message. If this value is "on" the address of the EIO card in slot 1 is shown. TRAY BEHAVIOR USE REQUESTED TRAY MANUAL FEED PROMPT PS DEFER MEDIA Specifies the behavior of the tray by indicating which tray the MFP should print from. USE REQUESTED TRAY sets the tray that the MFP should print from for specified jobs. The values for this menu item are EXCLUSIVELY (default) or FIRST. MANUAL FEED PROMPT determines whether or not the MFP prompts the user when a job does not match a requested configured tray. The values for this menu item are ALWAYS (default) or UNLESS LOADED. PS DEFER MEDIA sets whether the paper-handling model is based on PostScript rules or HP rules. The values for this menu item are ENABLED (default) or DISABLED. SLEEP DELAY=90 MINUTES 1 MINUTE 15 MINUTES 30 MINUTES 60 MINUTES 90 MINUTES 2 HOURS 4 HOURS Sets how long the MFP remains idle before it enters Sleep mode: ● Minimizes the amount of power consumed by the MFP when it is idle. ● Reduces wear on the MFP electronic components (turns off the display backlight). ● When you send a print job, press a control panel key, open a paper tray, or open the top cover, the MFP automatically exits Sleep mode. Note Sleep turns off the backlight on the display, but the display is still readable. WAKE TIME SUBMENU SETTING WAKE TIME Sets the time that the MFP automatically comes out of Sleep mode. This feature can be set for a different time for each day of the week. PERSONALITY=AUTO AUTO PCL PS PDF XHTML MIME Select the default product language (personality). Possible values are determined by which valid languages are installed in the MFP. Normally you should not change the product language (the default is AUTO). If you change it to a specific product language, the MFP does not automatically switch from one language to another unless specific software commands are sent to the MFP. CLEARABLE ON WARNINGS=JOB JOB Set the amount of time that a clearable warning appears on the printer control panel. ON: Warning messages appear on the control panel until they are cleared. JOB: Warning messages appear on the control panel until the end of the job from which they were generated. ENWW Configure device menu 205