HP Indigo 7500 Blanket Creep Troubleshooting - Page 5

Procedures, Identifying blanket creep, No blanket creep found

Get HP Indigo 7500 PDF manuals and user guides View all HP Indigo 7500 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 5 highlights

3 Procedures Follow below to troubleshoot blanket creep. Identifying blanket creep Follow the below steps to identify blanket creep. 1. Touch Print Care > Print Care Center > Maintenance > Maintenance Explorer > ATP > ATP wizards > Blanket Creep. 2. Print the Blanket creep job on wide substrate (330 mm width and 483 mm length). This job has an image that fills the entire sheet (full format).. 3. Check the prints for missing sections on either the left or right edge of the image. If there is blanket creep, the missing sections are usually visible in 2 of the 4 separations. See the example below. No blanket creep found If you have determined that there is no blanket creep, then there is probably an issue with the customer job. Therefore, fix the customer job and check the DFE settings. Do not continue with the instructions in this document. Blanket creep found Continue with the procedures below. Procedures 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
Procedures
3
Follow below to troubleshoot blanket creep.
Identifying blanket creep
Follow the below steps to identify blanket creep.
1. Touch
Print Care
>
Print Care Center
>
Maintenance
>
Maintenance Explorer
>
ATP
>
ATP wizards
>
Blanket Creep
.
2. Print the
Blanket creep
job on wide substrate (330 mm width and 483 mm length). This job has an
image that fills the entire sheet (full format)..
3. Check the prints for missing sections on either the left or right edge of the image.
If there is blanket creep, the missing sections are usually visible in 2 of the 4 separations. See the
example below.
No blanket creep found
If you have determined that there is no blanket creep, then there is probably an issue with the customer
job. Therefore, fix the customer job and check the DFE settings. Do not continue with the instructions in
this document.
Blanket creep found
Continue with the procedures below.
Procedures
3