HP C7745NB HP SureStore Tape Autoloader Model 1/9 Upgrade and Parts Replacemen - Page 15

Removing the Autoloader from a Rack

Page 15 highlights

Overview and Preparation for Upgrade Removing a Rackmounted Autoloader (if necessary) ADVERTENCIA Antes de empezar, baje las patas de nivelación del bastidor y abra el dispositivo estabilizador del mismo. En caso de no abrir el dispositivo estabilizador, existe el peligro de que se produzcan lesiones personales o daños al cargador automático de cintas si se vuelca el bastidor. Overview&Preparation Figure 1-2 Removing the Autoloader from a Rack To remove the autoloader from a rack, do the following: 1. Release the filler panel (and/or trim bracket) from the spacer bracket by releasing the screws from the clip nuts located at the front of the autoloader (see Figure 1-2). 2. Using two people or an appropriately rated lift, remove the autoloader by gently sliding it toward the front of the rack. 3. Place the autoloader on a stable surface in preparation for upgrade. Removing the Autoloader Chapter 1 1-5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63

Chapter 1
1-5
ADVERTENCIA
Antes de empezar, baje las patas de nivelación del bastidor y abra el
dispositivo estabilizador del mismo. En caso de no abrir el dispositivo
estabilizador, existe el peligro de que se produzcan lesiones personales
o daños al cargador automático de cintas si se vuelca el bastidor.
Removing the Autoloader from a Rack
To remove the autoloader from a rack, do the following:
1. Release the filler panel (and/or trim bracket) from the spacer bracket
by releasing the screws from the clip nuts located at the front of the
autoloader (see Figure 1-2).
2. Using two people or an appropriately rated lift, remove the
autoloader by gently sliding it toward the front of the rack.
3. Place the autoloader on a stable surface in preparation for upgrade.
Figure 1-2
Removing the Autoloader