GE JVW5301SJSS Installation Instructions - Page 4

INSTALLATION PREPARATION Installation Preparation TOOLS AND MATERIALS REQUIRED (NOT SUPPLIED) Safety glasses Pencil and tape measure Spirit level Wire cutter/stripper UL listed wire nuts Electric drill, #2 Phillips, flat head, and 9/32" drill bit Aluminized Duct tape Strain relief for junction box REMOVE THE PACKAGING CAUTION: Wear gloves to protect against sharp edges. • Remove the duct covers. • Remove the hardware bag, literature package and other boxed parts. • Remove and properly discard the protective plastic wrapping and other packaging materials. PLAN THE INSTALLATION CAUTION: To reduce risk of fire and to properly exhaust air, be sure to duct the air outside - Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces, or garages. PARTS SUPPLIED FOR INSTALLATION • 1 Hardware Package • 1 Literature Package PARTS NEEDED FOR INSTALLATION • 1 Strain Relief • Power Supply Cable • 1 Wall or Roof Cap (for external venting only) • All Metal Ductwork (for external venting only) • Recirculation Duct (for recirculation install only) WARNING: PERSONAL INJURY HAZARD Because of the weight and size of the range hood canopy. It is recommended that 2 people are used to install the range hood. Failure to properly lift range hood could result in damage to the product or personal injury. NOTE: This range hood can be installed as either ducted or recirculation. In a ducted application, this range hood can be vented through the wall or ceiling. When installed for recirculation, the range hood vents out the sides of the duct cover. NOTE: Before making any cuts or holes for installation, determine which venting method will be used and carefully calculate all measurements. 4 31-10983