Frigidaire FHPH142AC1 Complete Owners Guide - Page 23

23 CARE AND CLEANING Cleaning Clean your air conditioner occasionally to keep it looking new. Be sure to unplug the unit before cleaning to prevent shock or fire hazards. CLEANING THE UNIT The cabinet and front may be dusted with an oil-free cloth or washed with a cloth dampened in a solution of warm water and mild liquid dishwashing detergent. Never use harsh cleaners, wax or polish on the cabinet front. Be sure to wring excess water from the cloth before wiping around the controls. Excess water in or around the controls may cause damage to the air conditioner. CLEANING THE FILTERS To keep your air conditioner working e ciently, you should clean the filters every week of operation. This unit has two filters, they are filter A and B. Grasp the upper panel tab and take o the filter A which behind the grill of the back panel (Fig.26). Remove the lower filter B by loosening the screw. Take down the air inlet grille, then remove the air filter as shown in Fig.26. Wash the filter using liquid dishwashing detergent and warm water. Rinse filter thoroughly. Gently shake excess water from the filter. Be sure filter is thoroughly dry before replacing. Or, instead of washing you may vacuum the filter clean. Replace the filter after the filter is dry. Remove screw Take down filter Figure 26 Winter Storage If the air conditioner will not be used for an extended period of time: 1.Drain the water collection tank completely and leave the bottom drain cap and rubber plug o for an extended period of time to allow any residual. Once the tank is completely drained and no more water flows out, reinstall the rubber plug and cap. 2.Remove and clean the filter, allow it to dry completely, then reinstall it. 3.Remove the batteries from the remote control. 4.Store the air conditioner in a cool, dry location, away from direct sunlight, extreme temperature, and excessive dust. Before using the air conditioner again: 1.Make sure the filter and drain cap are in place. 2.Check the cord to make sure it is in good condition, without cracks or damage. 3.Place new batteries in the remote control. 4.Install the air conditioner as described in the Installation Instructions.