Frigidaire FHPH142AC1 Complete Owners Guide - Page 18
How to Use the Remote Control, Turning the unit on, Cool mode, Fan mode, Auto mode, Dry mode
View all Frigidaire FHPH142AC1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
18 OPERATING INSTRUCTIONS This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. How to Use the Remote Control Turning the unit on Plug in the unit, then press the "on·o " button When turned on, the unit will operate according to the last settings before shutdown. To switch the unit o , press "on·o " button again, then remove the plug. Do NOT switch the unit o by removing the plug. Always switch the unit o by pressing the "on·o " button and wait for few minutes before removing the plug. Note: In this mode, the fan speed will be set as "low" automatically, which cannot be changed. In this mode, condensate drainage is required, refer to the "Drainage Instructions" on Page 21 for more instructions to drain the excess condensate. Cool mode Press the "mode" button until the left side of LCD screen displays "cool". Press the "speed" button to choose the fan speed "auto", "high", "mid", and "low". Press the " " and " " button to choose the temperature you want. Fan mode Press the "mode" button until the left side of LCD screen displays "fan". In this mode, you can select fan speed "high", "mid", "low" by pressing the Fan speed button and referring to the diagram. Note: In this mode, the air exhaust hose does not need to be connected. Dry mode Press the "mode" button until the left side of LCD screen displays "dry". In this mode, the " " or " " button is disabled and the screen will remain blank. The unit will continuously drain moisture from the room. Auto mode Press the "mode" button until the left side of LCD screen displays "auto". Press the " " and " " button to choose the temperature you want. In this mode, the unit will automatically select cooling, heating(not applicable for