Fisher and Paykel WA42T26GW1 EcoSmart Clothes Washer Installation Instructions - Page 29

Changing pre-set options 27 US CA End of cycle beeps The beeps signaling the end of the cycle can be increased or decreased. 1 Enter the Option Adjustment Mode. 2 Use the WASH OPTION button to select the number of beeps you prefer. 3 Press POWER to store your selection. Number of beeps Light on TIME SAVER = SOAK = SOFTENER/ = BLEACH RINSE 15 beeps 5 beeps no beeps Default rinse option The normal rinse on the REGULAR and HEAVY DUTY cycles is a SPRAY RINSE. When you select SOFTENER/ BLEACH RINSE on these cycles the rinse changes to the default rinse. The default rinse is the rinse option used on the DELICATE and PERMANENT PRESS cycles. The default rinse is a SPRAY RINSE followed by a DEEP RINSE. However, you can change the default rinse to two deep rinses (as is used on the ALLERGY cycle). Rinse option Light on 1st rinse MED spin deep rinse SLOW spin - HOLD spray rinse 1 Enter the Option Adjustment Mode. 2 Use the SPIN SPEED buttons to select the rinse option you prefer. 3 Press POWER to store your selection. 2nd rinse deep rinse - deep rinse Volume of water used in the spray rinse (REGULAR cycle) You can increase or decrease the volume of water added during the rinse on the REGULAR cycle. 1 Enter the Option Adjustment Mode. 2 Use the WATER LEVEL buttons to select the volume of water you wish to be used in the spray rinse. 3 Press POWER to store your selection. Spray rinse volume Light on HIGH = more water MED = more water LOW = FACTORY SETTING Controlled cold Ecosmart™ is designed for installations that have both hot and cold water. To ensure optimum performance even in very cold weather, the cold water temperature is controlled to 60˚F (15.6˚C). However, if for some reason you do not have hot water available you may need to change to uncontrolled cold in very cold weather. Controlled cold options Light color Green = controlled cold Amber = uncontrolled cold Ecosmart™ leaves the factory with the CONTROLLED COLD Option set. You can change this by entering the Option Adjustment mode and by pressing the ADVANCE button once.