Epson Powerspan User Manual - Page 143
installed in the lowest bay before inserting the cable into
View all Epson Powerspan manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 143 highlights
3. Choose a connector for each SCSI drive you have installed. Align the tab on the connector with the notch in the drive socket. Make sure the holes fit over all the pins, and then push in the connector. If you are installing up to four SCSI drives, be sure to use P7 for the last drive on the bus. Then proceed to "Installing the SCSI power cables" on page 7-25. If you are installing five or six SCSI drives, continue with the next step. 4. There is a cutout beneath the external bays and above drive bay 4, as shown in the previous illustration. Insert the section of the cable that contains connectors P6 and P7 through this cutout. Make sure the red stripe on the cable faces the outside of the computer and that connectors P6 and P7 are behind the external drive bays. Note If you have difficulty routing the cable beneath the external drive bays, you may want to remove the device installed in the lowest bay before inserting the cable into the cutout. See "Removing a Drive from an External Bay" on page 7-8 for instructions. 5. Connect P6 or P7 of the SCSI ribbon cable to the SCSI device that you installed in either the IDE drive bay or the external drive bay. Be sure to connect P7 of the SCSI ribbon cable to your last SCSI device. Now follow the instructions in the next section to connect the power cables. 7-24 Installing and Removing Disk Drives