Epson LightScene EV-100 Quick Setup - Page 1

LightScene EV-100/LightScene EV-105 Quick Setup Before using the projector, make sure you read the safety instructions in the online User's Guide. External speakers Connect one end of a 3.5 mm stereo mini-jack audio cable to the projector's Audio Out port and the other end to your powered external speakers. Contents Make sure your projector box included all of these parts: Using the remote control Install the batteries as shown (two AA batteries). Installation options You can install your projector in the following ways: •• Mounted on a wall or ceiling using the direct mount (included) •• Mounted on a lighting track using the optional lighting track mount (ELPMB54) •• Mounted on a table or floor using the optional floor stand (ELPMB55) Note: To purchase optional mounts or other accessories, see "Optional accessories." For more information about the mounts, see the Installation Manual that came with the mount or the online User's Guide. Connect the projector Choose from the following connections. See the sections below or the online User's Guide for details. Wired network Connect the projector to your network using an Ethernet cable. See "Setting up a wired connection" for more information. Turn projector on and off Access projector menus Adjust projector focus Display a test pattern Display playlists on SD card Switch to spotlight mode Select a playlist on SD card Access playlists you assigned to each of the numeric buttons (1 to 9) Navigate projector menus Control projector volume Change image shape and color For more information on using the remote control, see the online User's Guide. Turn on your equipment Note: Your connection method may vary depending on your setup. 1 Connect your computer, video equipment, or insert an SD card. 2 Make sure the power cord is connected and plugged into an electrical outlet. Computer or video device Connect one end of an HDMI cable to the projector's HDMI port and the other end to an HDMI port on your computer or video device. HDMI cable 3 Press the power button on the projector or remote control. The Status light flashes blue and then stays on. Note: To shut down the projector, press the power button twice.