Epson LightScene EV-100 Installation Manual - Page 17
Installing the Safety Wire, d
View all Epson LightScene EV-100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Installation Procedure Installing the Safety Wire Install the safety wire supplied to prevent the projector from falling. Caution Attach the wire firmly so that it cannot come loose. a Attach the wire hook mount supplied to the ceiling or the wall. c • When installing the wire hook mount, use commercially available wood screws with a nominal diameter of 3.8 mm. • Make sure that the wood screws enter at least 20 mm into the ceiling or underlying wall. b Loosen the carabiner for the safety wire supplied. c Insert the loosened carabiner through the shaft of the ceiling mount, and then tighten. d Attach the carabiner for the safety wire to the wire hook mount attached to the ceiling or the wall. 16
Installation Procedure
16
Installing the Safety Wire
Install the safety wire supplied to prevent the projector from falling.
Caution
Attach the wire firmly so that it cannot come loose.
a
Attach the wire hook mount supplied to the ceiling or the wall.
c
•
When installing the wire hook mount, use commercially available wood screws with a nominal
diameter of 3.8 mm.
•
Make sure that the wood screws enter at least 20 mm into the ceiling or underlying wall.
b
Loosen the carabiner for the safety wire supplied.
c
Insert the loosened carabiner through the shaft of the ceiling mount, and then tighten.
d
Attach the carabiner for the safety wire to the wire hook mount attached to the ceiling or
the wall.