Denon DP 300F Owners Manual - English - Page 5
English - cartridge
UPC - 081757506915
View all Denon DP 300F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Getting Started Square hole Center spindle Turntable sheet Turntable Ribbon tape Counterweight Stylus pressure adjustment ring Twist tie for clamping the tone arm Tone arm Lock nut Head shell with cartridge Roller Belt Ribbon tape Square hole Equalizer switch ENGLISH About the equalizer switch Mounting the counterweight Getting Started This record player comes with a built-in equalizer. Switch as shown below according to the terminal being used. OFF: When connecting to the PHONO input terminal (The record player's equalizer cannot be used.) ON: When connecting a terminal other than the PHONO input terminal (The record player's equalizer can be used.) • The equalizer switch is set to the "ON" position upon shipment from the factory. Be sure to check before mounting the turntable and turntable sheet. • The sound may be extremely weak or distorted if the equalizer switch is not properly set. Assembly NOTE: • Do not remove the twist tie for clamping the tone arm until assembly is completed. • Do not connect the power supply cord until assembly is completed. Insert the counterweight onto the shaft at the back of the tone arm and screw it in. Mount with the stylus pressure adjustment ring towards the front. Mounting the head shell with cartridge Insert the head shell with cartridge onto the tone arm and fasten it in place with the lock nut ( page 6). Mounting the dust cover Dust cover Hinge Hinge retainer section Holder Cabinet 1 Insert the 2 included hinges securely into the holders at the back of the cabinet. Mounting the turntable 1 Mount the turntable on the center spindle. 2 Turn the turntable so that the roller is visible through the square hole with the ribbon tape for catching the belt. 3 Pinch the ribbon tape and catch the belt on the outer center of the roller. • Remove the ribbon tape once the belt is caught. • Turn turntable slowly 5 or 6 turns. The belt is caught at the center of the roller. 2 Mount the hinge retainer sections of the dust cover onto the hinges. • Insert fully in the direction of the arrow. • When removing the dust cover, open the dust cover fully then pull out in the direction opposite the arrow. • Hold the dust cover near the hinge retainer sections when mounting and removing it. Once assembly is finished, remove the twist tie for clamping the tone arm. 4 Mount the turntable sheet. 2 ENGLISH