Denon DP 300F Owners Manual - English - Page 10

ENGLISH Others Troubleshooting If a problem should arise, first check the following. 1. Are the connections correct? 2. Have you operated the player according to the Operating Instructions? If this unit is not operating properly, check the items listed in the table below. Should the problem persist, there may be a malfunction. Disconnect the power immediately and contact your store of purchase. Symptom Cause Measures Page • Power supply cord is not fully • Check the connection. 4 inserted. • Drive belt is detached from the • Check the drive belt and driving roller. 2 turntable. If the drive belt is detached from the turntable, attach it using the procedure described below. Power does not turn 1.Remove the turntable and turn it on. upside down. Turntable does not turn. 2.Catch the belt on the inside perimeter. 3.Turn the turntable back right side up and pass the tape ribbon through the hole and between the turn tape and drive belt. 4.Mount the turntable, referring to the assembly instructions on page 2. • The pin-plug cable is not properly • Check the connection. 4 connected. • The amplifier's function is not set for • Check the amplifier's settings. 4 No sound is produced. the terminals to which the turntable is connected. • The replaceable stylus is not properly • Check the stylus. 7 mounted. The sound is scratchy, the stylus skips or the • The stylus or record is dirty. • Remove the dirt or replace the stylus. • The stylus is worn or the record is • Replace the stylus. 7 7 sound is distorted. scratched. • Check the record. - The sound is either • The equalizer switch is not set at the • Set the switch according to the 2 extremely weak or too proper position. terminal to which the player is strong and distorted. connected. • The player is too close to the • Move the player and speakers apart. - speakers. Howling is produced. • The player is placed in an unstable • Check the player's place of installation. - position. • The playback sound is too loud. • Adjust the amplifier's volume. - The tone arm does not • The tone arm is clamped to the • Remove the tone arm's clamp. 2 move even when the armrest. START button is • The power supply cord is not properly • Check the connection of the power 4 pressed. connected. supply cord. Specifications Power supply: AC 120 V, 60 Hz Power consumption: 2 W Maximum external dimensions: With dust cover closed : 434 (W) x 122 (H) x 381 (D) mm (17-3/32" x 4-51/64" x 15") (including protruding parts) With dust cover open : 434 (W) x 386 (H) x 413 (D) mm (17-3/32" x 15-13/64" x 16-19/64") (including protruding parts) Mass: 5.5 kg (12 lbs 2 oz) Drive type: Belt drive Motor: DC servo motor Speed: 33-1/3 rpm, 45 rpm Wow & flutter: 0.10 % W.R.M.S S/N ratio: 60 dB Tone arm: Static balance straight type tone arm Effective arm length: 221.5 mm Overhang: 19 mm Cartridge: MM type Output voltage: With equalizer OFF : 2.5 mV With equalizer ON : 150 mV Optimum stylus pressure: 2.0 g Replaceable stylus number: DSN-85 Stylus pressure adjustment range: 0 ~ 4.0 g One step 0.1 g Suitable cartridge empty weight : 4.5 ~ 9.5 g Head shell weight: 10.0 g (including screws and nuts) Head shell part number: PCL-310BK * For purposes of improvement, specifications and design are subject to change without notice. 7 ENGLISH