Denon AVR-1611 Owners Manual - English - Page 75
Resetting the microprocessor - in protection mode
UPC - 883795001328
View all Denon AVR-1611 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
ENGLISH GHDMIH Symptom Cause/Solution No audio is output with HDMI connection. • Check the connection of the HDMI connectors. • When outputting HDMI audio from the speakers, set "HDMI Audio Out" on the menu to "Amp". • When outputting HDMI audio from a TV, set "HDMI Audio Out" on the menu to "TV". No video is output with HDMI connection. • Check the connection of the HDMI connectors. • Set the input source to match the connected HDMI connector. • Check whether the TV is compatible with copyright protection (HDCP). If connected to a device not compatible with HDCP, video will not be output correctly. When the following • Set "HDMI Control" on the menu to "OFF". To operate power operations are only for each device, set "Power Off Control" to "OFF". performed on devices compatible with HDMI control, the same operations occur on this unit. • Power ON/OFF • Switching audio output devices • Adjust volume • Switch input source Page 14 51 51 14 14, 19, 20 14 32, 51 GRadioH Symptom Cause/Solution Reception fails, or there is a lot of noise or distortion. • Change the antenna orientation or position. • Separate the AM loop antenna from the unit. • Use an FM outdoor antenna. • Separate the antenna from other connection cables. Page 18 18 18 18 GiPodH Symptom iPod cannot be played. "Connection Error" is displayed. "Not Support" is displayed. "Connection Error" is displayed. Cause/Solution • Check the iPod connections. • Plug the control dock for iPod's AC adapter into a power outlet. • Switch the input source to "DOCK". • Unable to communicate properly. Turn off the power to this unit, disconnect the iPod and then reconnect it. • The iPod connected to the unit is not compatible. Please make sure the iPod you are connecting is compatible. • The software version of the connected iPod is an old one. Please update to the latest version. • The iPod is not responding. Turn off the power to this unit, disconnect the iPod and then reconnect it. Page 18 - 19, 20 - 21 - - GRemote control unitH Symptom Cause/Solution The set cannot be operated with the remote control unit. • Batteries are worn out. Replace with new batteries. • Operate the remote control unit within a distance of about 23 ft / 7 m from this unit and at an angle of within 30°. • Remove any obstacle between this unit and the remote control unit. • Insert the batteries in the proper direction, checking the q and w marks. • The set's remote control sensor is exposed to strong light (direct sunlight, inverter type fluorescent bulb light, etc.). Move the set to a place in which the remote control sensor will not be exposed to strong light. Page 64 64 64 64 64 Resetting the microprocessor Perform this procedure if the display is abnormal or if operations cannot be performed. When the microprocessor is reset, all the settings are reset to their default values. ON/STANDBY SURROUND MODE 1 SURROUND MODE 0 1 Turn off the power using ON/STANDBY. 2 Press ON/STANDBY while simultaneously pressing SURROUND MODE 0 and SURROUND MODE 1. 3 Once the display starts flashing at intervals of about 1 second, release the two buttons. If in step 3 the display does not flash at intervals of about 1 second, start over from step 1. 72