Adaptec 19160 User Reference - Page 17

the cable. - card

Get Adaptec 19160 - SCSI Card Storage Controller U160 160 MBps PDF manuals and user guides
UPC - 760884155189
View all Adaptec 19160 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

Troubleshooting "Attention! Too many devices are terminated on the SE connectors"2 The SCSI card BIOS has detected that more than two devices have been terminated on the narrow SE SCSI segment. Verify the termination on the devices connected to the internal and external connectors. Terminate only the SCSI device at the ends of the cable. Remove or disable the terminators on the SCSI devices between the ends of the cable. "Attention! Insufficient termination detected on the SE connectors"2 The SCSI card BIOS has detected that either only one or no devices have been terminated on the narrow SE SCSI segment. Verify the termination on the devices connected to the SE connectors. Terminate the SCSI devices at the end of the cables and leave the other devices unterminated. 2 The termination detection feature is only implemented on the internal narrow SE connectors. The 68-pin LVD/SE connector does not support this feature. 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
11
Troubleshooting
“Attention! Too many devices are terminated on the SE connectors”
2
The SCSI card BIOS has detected that more than two devices have
been terminated on the narrow SE SCSI segment. Verify the termina-
tion on the devices connected to the internal and external connec-
tors. Terminate
only
the SCSI device at the ends of the cable. Remove
or disable the terminators on the SCSI devices between the ends of
the cable.
“Attention! Insufficient termination detected on the SE connectors”
2
The SCSI card BIOS has detected that either
only one
or
no
devices
have been terminated on the narrow SE SCSI segment. Verify the ter-
mination on the devices connected to the SE connectors. Terminate
the SCSI devices at the end of the cables and leave the other devices
unterminated.
2
The termination detection feature is only implemented on the internal
narrow SE connectors. The 68-pin LVD/SE connector does not support this
feature.