Home » Actiontec Manuals » Electronics Accessories » Actiontec MWTV2TX » Manual Viewer

Actiontec MWTV2TX User Manual - Page 18

I'm connected to a Cable box and seeing one of the following issues: snowy display

Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

I'm connected to a Cable box and seeing one of the following issues: snowy display, or video appears only once, or black/blank screen, or distorted green/pink image. The Cable box might be an older generation and is not fully HDCP-compliant. Please check support site for further details. Nothing is displaying on the TV connected to the Receiver after it's turned on, and both the LINK and POWER lights are on. Make sure the HDMI cable is connected from Receiver to TV, power on the TV with the correct input selected, and then power-cycle the Receiver. 16

Section	Page
Part I. Introduction	3
1.1. Features	3
1.2. Minimum System Requirements	4
1.3. Package Contents	4
1.4. Getting To Know MyWirelessTV 2	4
1.4.1. MyWirelessTV 2 Transmitter	4
1.4.2. MyWirelessTV 2 Receiver	5
Part II. Connecting MyWirelessTV 2	7
2.1. Typical MyWirelessTV Connection Configuration	7
2.1.1. Transmitter	7
2.1.2. Receiver	8
2.2. Connecting the MyWirelessTV Transmitter	8
2.3. Connecting the MyWirelessTV Receiver	9
2.4. Setting up IR Control	9
2.4.1. Connecting the IR Blaster Cable	9
2.4.2. Connecting the IR Receiver Extension Cable	10
Part III. Configuring MyWirelessTV 2	11
3.1. Graphical User Interface	11
3.1.1. Language	11
3.1.2. Video Mode	12
3.1.3. Pairing	13
3.1.4. Exit	14
3.1.5. System Information	15
3.2. Resetting to Defaults	15
3.3. Updating MyWirelessTV Firmware	15
Appendix I. Troubleshooting	17
FAQs	17

Match case Limit results 1 per page

I'm connected to a Cable box and seeing one of the following issues: snowy display,

or video appears only once, or black/blank screen, or distorted green/pink image.

The Cable box might be an older generation and is not fully HDCP-compliant. Please check

support site for further details.

Nothing is displaying on the TV connected to the Receiver after it's turned on, and

both the LINK and POWER lights are on.

Make sure the HDMI cable is connected from Receiver to TV, power on the TV with the

correct input selected, and then power-cycle the Receiver.