2011 Yamaha Motorsports C3 Owners Manual - Page 58
2011 Yamaha Motorsports C3 Manual
Page 58 highlights
EAU1722A PERIODIC MAINTENANCE AND ADJUSTMENT turned to "OFF", then disconnect the negative lead before disconnecting the positive lead.[ECA16302] 2. If the battery will be stored for more than two months, check it at least once a month and fully charge it if necessary. 3. Fully charge the battery before installation. 4. After installation, make sure that the battery leads are properly connected to the battery terminals. ECAT1053 EAUT2023 Replacing the fuse 1 2 3 4 5 6 7 8 9 installing the main fuse, be sure to turn the main switch from "ON" to "OFF" three times in 3 seconds intervals to initialize the idle speed control system.[ECAT1062] Specified fuse: 15 A 1 ZAUM00** 1. Fuse NOTICE ● Always keep the battery charged. Storing a discharged battery can cause permanent battery damage. ● After installing the battery, be sure to turn the main switch from "ON" to "OFF" three times in 3 seconds intervals to initialize the idle speed control system. The fuse holder is located beside the battery. Remove panel C to access the fuse. (See page 6-8.) If the fuse is blown, replace it as follows. 1. Turn the key to "OFF" and turn off all electrical circuits. 2. Remove the blown fuse, and then install a new fuse of the specified amperage. WARNING! Do not use a fuse of a higher amperage rating than recommended to avoid causing extensive damage to the electrical system and possibly a fi re. [EWA15131] NOTICE: After removing and 6-23 3. Turn the key to "ON" and turn on the electrical circuits to check if the devices operate. 4. If the fuse immediately blows again, have a Yamaha dealer check the electrical system.