2011 Yamaha Motorsports Big Bear 400 4x4 IRS Owners Manual - Page 95
2011 Yamaha Motorsports Big Bear 400 4x4 IRS Manual
Page 95 highlights
Recommended oil: See page 10-1. Oil quantity: Without oil filter element replacement: 2.90 L (3.07 US qt, 2.55 Imp.qt) With oil filter element replacement: 3.00 L (3.17 US qt, 2.64 Imp.qt) TIP Be sure to wipe off spilled oil on any parts after the engine and exhaust system have cooled down. ECB00300 11. Start the engine, and then let it idle for several minutes while checking it for oil leakage. If oil is leaking, immediately turn the engine off and check for the cause. 12. Turn the engine off, wait at least ten minutes, and then check the oil level and correct it if necessary. EBU28564 Final gear oil The final gear case must be checked for oil leakage before each ride. If any leakage is found, have a Yamaha dealer check and repair the ATV. In addition, the final gear oil level must be checked and the oil changed as follows at the intervals specified in the periodic maintenance and lubrication chart. To check the final gear oil level 1. Place the ATV on a level surface. 2. Remove the final gear oil filler bolt and its Oring, and then check the oil level in the final gear case. The oil level should be at the brim of the filler hole. NOTICE G In order to prevent clutch slippage (since the engine oil also lubricates the clutch), do not mix any chemical additives. Do not use oils with a diesel specification of "CD" or oils of a higher quality than specified. In addition, do not use oils labeled "ENERGY CONSERVING II" or higher. G Make sure that no foreign material enters the crankcase. 8 8-15