2009 Yamaha Motorsports Apex LTX Owners Manual - Page 32
2009 Yamaha Motorsports Apex LTX Manual
Page 32 highlights
Control functions Rebound damping setting: Minimum (soft): 11 click(s) in direction (b)* Maximum (hard): 11 click(s) in direction (a)* * With the adjustment dial in the standard position RX10RTR The compression damping force can be adjusted by turning the adjusting screw. To increase the compression damping force, turn the adjusting screw in direction (a). To decrease the compression damping force, turn the adjusting screw in direction (b). NOTICE: Do not continue to turn the adjusting screw in direction (a) after it stops. The shock absorber could be damaged and damping force adjustments will not be able to be made. Do not turn the adjusting screw in direction (b) more than 20 click(s). Even if the adjusting screw is continually turned after 20 click(s), there will be no change in the damping force. Be sure to stop the adjusting screw at a position where there is a click. [ECS00301] Compression damping setting: Minimum (soft): 20 click(s) in direction (b)* Standard: 11 click(s) in direction (b)* Maximum (hard): 1 click(s) in direction (b)* * With the adjusting screw fully turned in direction (a) ESU11044 Adjusting the control rods The weight transfer can be adjusted by turning the adjuster on the control rod (RX10R / RX10LT) or the adjusting nuts on the control rods (RX10RTR / RX10MT). RX10R / RX10LT 1. Check the control rod length using the scale on the special wrench as shown. 3 1 2 1. Special wrench 2. Control rod length 3. Scale range TIP Use the special wrench in the owner's tool kit to make this adjustment. 1. Compression damping force adjusting screw 2. Loosen the locknut. 26