2008 Yamaha Motorsports Phazer R-TX Owners Manual - Page 63
2008 Yamaha Motorsports Phazer R-TX Manual
Page 63 highlights
Periodic maintenance 2. Remove the coolant reservoir cap, add the recommended coolant until it reaches the "COLD LEVEL" mark, and then install the cap. NOTE: If you find any leaks, consult a Yamaha dealer. 5. Install the right upper cover, and then install the top cover (PZ50RT / PZ50GT / PZ50MT) or close the shroud (PZ50VT). ESU12080 V-belt EWS00400 WARNING G 1. "COLD LEVEL" mark 2. Coolant reservoir cap G Make sure that the drive guard is tightened securely before operating the snowmobile. Never run the engine with the V-belt or drive guard removed. Recommended antifreeze: High-quality ethylene glycol antifreeze containing corrosion inhibitors Antifreeze and water mixing ratio: 3:2 Total amount: PZ50GT 3.60 L (3.81 US qt) (3.17 Imp.qt) PZ50MT 3.60 L (3.81 US qt) (3.17 Imp.qt) PZ50RT 3.60 L (3.81 US qt) (3.17 Imp.qt) PZ50VT 3.70 L (3.91 US qt) (3.26 Imp.qt) 3. 4. Start the engine, allow it to idle for several minutes, and then turn it off. Check for any coolant leakage. The V-belt should be checked before each ride. To check the V-belt 1. Remove the left side cover (PZ50RT / PZ50GT / PZ50MT), or open the shroud and remove the left upper cover and the left side cover (PZ50VT). (See page 45 for removal procedure.) 2. Remove the drive guard. 3. Check the V-belt for wear and damage. Replace if necessary. 1. V-belt wear limit New V-belt width: 34.1 mm (1.34 in) V-belt wear limit width: 32.5 mm (1.28 in) 57