2008 Yamaha Motorsports Grizzly 125 Automatic Owners Manual - Page 86
2008 Yamaha Motorsports Grizzly 125 Automatic Manual
Page 86 highlights
fall out. Take care not to lose these parts. 1 2 3 4 5 6 7 8 9 10 11 ECB00330 5. Clean the oil strainer with solvent. 6. Check the O-ring for damage and replace it if necessary. 7. Install the O-ring, oil strainer, compression spring and drain bolt. Tighten the engine oil drain bolt to the specified torque. ECB00320 CAUTION: G G Do not use oils with a diesel specification of "CD" or oils of a higher quality than specified. In addition, do not use oils labeled "ENERGY CONSERVING II" or higher. Make sure that no foreign material enters the crankcase. CAUTION: Before installing the engine oil drain bolt, be sure to install the O-ring, compression spring and oil strainer. Tightening torque: Engine oil drain bolt: 32 Nm (3.2 m·kgf, 23.1 ft·lbf) 8. Add the specified amount of the recommended engine oil, and then install and tighten the engine oil filler cap. Recommended oil: See page 10-1. Oil quantity: 1.25 L (1.32 US qt) (1.10 Imp.qt) 8-12 9. Start the engine, and then let it idle for several minutes while checking it for oil leakage. If oil is leaking, immediately turn the engine off and check for the cause. 10. Turn the engine off, wait at least ten minutes, and then check the oil level and correct it if necessary. EBU27021 Transmission oil The transmission oil level should be checked before each ride. In addition, the transmission oil must be changed at the intervals specified in the periodic maintenance and lubrication chart. To check the transmission oil level 1. Place the ATV on a level surface. 2. Start the engine, warm it up for several min-