2007 Yamaha Motorsports Nytro Owners Manual - Page 89
2007 Yamaha Motorsports Nytro Manual
Page 89 highlights
E_8gg.book Page 34 Thursday, March 16, 2006 4:23 PM 2. Loosen the handlebar bolts. 3. Move the handlebar up or down to adjust the handlebar height to the desired position. CAUTION: @ Make sure that the projection on the handlebar is not installed into the area a shown. @ 4. Tighten the handlebar bolts and install the handlebar cover. Handlebar bolt tightening torque: 14.5 Nm (1.45 m·kgf, 10.5 ft·lb) CAUTION: @ Make sure that the small gap b side of the handlebar holders faces forward c. @ 8-34
8-34
2. Loosen the handlebar bolts.
3. Move the handlebar up or down to adjust the handle-
bar height to the desired position.
CAUTION
:
@
Make sure that the projection on the handlebar is not
installed into the area
a
shown.
@
4. Tighten the handlebar bolts and install the handlebar
cover.
CAUTION
:
@
Make sure that the small gap
b
side of the handlebar
holders faces forward
c
.
@
Handlebar bolt tightening torque:
14.5 Nm (1.45 m·kgf, 10.5 ft·lb)
E_8gg.book
Page 34
Thursday, March 16, 2006
4:23 PM