2013 Volvo S80 Owner's Manual - Page 94

03 Your driving environment Lighting Position Description Low beams/high beams/high beam flash "Tunnel detection"* will activate the low beams in poor lighting conditions The "Active high beam"* function can be used High beam flash Headlight switch with AUTO and lever between high and low beams (this also applies on models equipped with the optional Active Bending Lights). > The symbol illuminates in the instrument panel to indicate that the high beams are on. 03 Low beams When the engine is started, the low beams are activated automatically (daytime running lights) if the headlight control is in position 0 or . Daytime running lights can be deactivated in the MY CAR menu system under Settings Car settings Light settings Daytime running lights. However, please be aware that these lights may not be deactivated in Canada. High beam flash Toggle between high and low beams Low beams/high beams/high beam flash Volvo recommends using the position whenever weather conditions allow the use of the "Active high beam"* function (see page 93). Position Description Daytime running lights/high beams/high beam flash Parking lights High beam flash Move the lever toward the steering wheel to position 1. The high beams come on until the lever is released. NOTE • • The use of daytime running lights is mandatory in Canada. Continuous high beams cannot be activated when the headlight switch is in . High beam flash will position function in this position. High/low beam headlights Continuous high beams 1. Set the ignition to mode II. 2. With the light switch in position 0 or , pull the turn signal lever toward the steering wheel to position 2 to toggle 92 * Option/accessory, for more information, see Introduction.