2007 Volvo S40 Owner's Manual - Page 74

where the hanging antenna wire is attached to the unit). If there is difficulty locating the training button reference the garage door opener's manual or contact us. 6. Press and release the "learn" or "smart" button (the name and color of the button may vary by manufacturer). NOTE Once the button is pressed, there are 30 seconds in which to initiate the next step. 7. Return to the vehicle and firmly press and hold the trained HomeLink button for two seconds and release. Repeat the "press/hold/release" sequence up to 3 times to complete the training process. NOTE During programming, your hand-held transmitter may automatically stop transmitting. Continue to press and hold the desired HomeLink button while you press and repress ("cycle") your hand-held transmitter every two seconds until the frequency signal has been learned. The indicator light will flash slowly and then rapidly after several seconds upon successful training. If necessary, follow steps 5-7 to complete the training for a rolling code device. To train additional HomeLink buttons, begin with step two. Rolling Code Programming Rolling code garage door openers that are "code-protected" and manufactured after 1996 may be determined by thefollowing: Reference the garage door opener owner's manual for verification. The handheld transmitter appears to program the HomeLink Universal Transceiver but does not activate the garage door. Press and hold the trained HomeLink button. The garage door opener has the rolling code feature if the indicator light flashes rapidly and then turns solid after 2 seconds. To train a garage door with the rolling code feature, follow these instructions (the aid of a second person may make the training quicker and easier): 1. Locate the training button on the garage door opener motor head unit. Exact location and color of the button may vary by garage door opener brand. If there is difficulty locating the training button, reference the garage door opener owner's manual or please visit our Web site at www.HomeLink.com. 2. Press the training button on the garage door opener motor head unit (which activates the "training light"). NOTE Following step 2, there are 30 seconds in which to initiate step 3. 3. Firmly press and release the programmed HomeLink® button. Press and release the HomeLink button a second time to complete the training process. (Some garage door openers may require 79 02 Instruments and controls Home Link® Universal Transceiver (option) you to do this procedure a third time to complete the training.)