2013 Polaris Ranger 800 Midsize Owners Manual - Page 23
2013 Polaris Ranger 800 Midsize Manual
Page 23 highlights
FEATURES AND CONTROLS Seat Belts This POLARIS vehicle is equipped with three-point lap and diagonal seat belts on all external seats. Always make sure the seat belts are secured for all riders before operating. WARNING! Falling from a moving vehicle could result in serious injury or death. Always fasten your seat belt securely before operating or riding in the RANGER. Latch Plate To wear the seat belt properly, follow this procedure: 1. For 3-point belts, pull the seat belt latch downward and across your chest toward the buckle at the inner edge of the seat. The belt should fit snugly across your hips and diagonally across your chest. Make sure the belt is not twisted. 2. Push the latch plate into the buckle until it clicks. 3. Release the strap, it will self tighten. Tip: The center belt must be tightened manually by pulling on the strap. Buckle 4. To release the seat belt, press the square red button in the buckle's center. Seat Belt Inspection Inspect all seat belts for proper operation before each use of the vehicle. 1. Push the latch plate into the buckle until it clicks. The latch plate must slide smoothly into the buckle. A click indicates that it's securely latched. 2. Push the red release latch in the middle of the buckle to make sure it releases freely. 3. Pull each seat belt completely out and inspect the full length for any damage, including cuts, wear, fraying or stiffness. If any damage is found, or if the seat belt does not operate properly, have the seat belt system checked and/or replaced by an authorized POLARIS dealer. 4. To clean dirt or debris from the seat belts, sponge the straps with mild soap and water. Do not use bleach, dye or household detergents. 21