2011 Polaris 600 Shift 136 Owners Manual - Page 43
2011 Polaris 600 Shift 136 Manual
Page 43 highlights
FEATURES Instrumentation MFD Battery Replacement (models with clocks) If the clock function of the MFD isn't working properly, replace the battery. Replacement batteries are available from your dealer. 1. Remove the plenum from the underside of the hood. 2. Locate the black battery compartment. It has a red wire and a brown wire with a white stripe. It's located about three inches down the main harness from the point where the harness connects to the MFD. 3. Cut the plastic cable tie from the outside of the compartment. 4. Carefully cut the bottom of the compartment (opposite the wires) to separate the heat-sealed seams. Squeeze the corners of the compartment inward so the battery is visible. TIP: Note the orientation of the battery before removing it. An incorrectly installed battery will not maintain the clock. 5. Using needle-nose pliers, grasp the battery and rotate it so the leading edge of the battery is raised slightly away from the battery holder. Pull the battery out gently. TIP: The battery will not come out of the holder unless the leading edge of the battery is raised. Hold the battery compartment, not the wires, while removing the battery. Pulling on the wires will separate them from the battery holder. 39