2008 Polaris 600 IQ LX Owners Manual - Page 137

TROUBLESHOOTING Problem Rear suspension bottoms too easily IQ/Switchback Suspension Troubleshooting Solution • Adjust torsion spring preload to achieve proper static sag (see page 50). • Change torsion spring to stiffer optional spring (see your dealer). • Revalve rear track shock (see your dealer). • Check for binding suspension shafts and grease all pivot points. • Adjust torsion spring preload to achieve proper static sag (see page 50). • Change torsion spring to softer optional spring (see your dealer). • Check track tension (see page 120). • Set static sag (see page 50). Adjust torsion spring blocks or install optional torsion springs to achieve correct sag. • Adjust limiter straps (see page 53). • Set static sag (see page 50). Adjust torsion spring blocks or install optional torsion springs to achieve correct sag. • Adjust limiter straps (see page 53). • Check ski alignment (see page 124). • Make sure spindles and all steering components turn freely. • Check for excessive play in steering assembly (see your dealer). • Ensure skags are straight on skis. • Set static sag (see page 50). • Check rail slide/replace if worn (see page 126). • Install Accu-Trak dual skags (see your dealer). • Check for worn skags. • Set static sag (see page 50). • Check for binding front suspension shafts and steering components, grease all pivot points (elevate front of machine). • Increase IFS preload (if equipped) (see page 46). • Install single skag (see your dealer). • Rotate RRSS to high position (see page 57 Make sure spindles and all steering components turn freely. Check ski alignment (see page 124). Check skags and skis for damage. Set static sag (see page 50). Rides too stiff in rear Too much weight transfer when climbing Too little weight transfer when climbing Machine darts from side to side Front end pushes Steering is heavy 134