2008 Polaris 340 Edge Owners Manual - Page 97
2008 Polaris 340 Edge Manual
Page 97 highlights
MAINTENANCE Clutch System n Drive Belt Deflection Measure belt deflection with both clutches at rest and in their full neutral position. Place a straight edge (1) on the belt and apply downward pressure while measuring at point 2. This measurement should be 1 1/4I (3.2 cm). 2 1 Drive Belt Adjustment Belt deflection should be adjusted without removing the clutch from the jackshaft. 1. Loosen the 7/16I jam nut on the belt width adjuster. 2. Using a 1/8I Allen wrench, adjust the threaded set screw as needed. NOTE: Turn the set screw in (clockwise) to increase the distance between the sheaves and out (counterclockwise) to decrease the distance. 3. Tighten the jam nut. 94
94
MAINTENANCE
Clutch System
n
Drive Belt Deflection
Measure belt deflection with
both clutches at rest and in
their full neutral position.
Place a straight edge (1) on the
belt and apply downward pres-
sure while measuring at point
2. This measurement should be
1 1/4
I
(3.2 cm).
Drive Belt Adjustment
Belt deflection should be adjusted without removing the clutch from the
jackshaft.
1.
Loosen the 7/16
I
jam nut on the belt width adjuster.
2.
Using a 1/8
I
Allen wrench, adjust the threaded set screw as needed.
NOTE:
Turn the set screw in (clockwise) to increase the distance
between the sheaves and out (counterclockwise) to decrease
the distance.
3.
Tighten the jam nut.
1
2