1996 Oldsmobile Aurora Owner's Manual - Page 141
1996 Oldsmobile Aurora Manual
Page 141 highlights
Automatic Operation Press the AUTO-PUSH knob when you want thesystem to automatically adjust to changes in the temperature inside the vehicle, the outside temperature and the sun load on the vehicle. When the system is set for automatic operation, air will come from the floor, upper or thewindshield outlets depending on the temperature inside the vehicle, the outside temperature and the sun load. Fan speed will vary as the system reaches and maintains the comfort setting you have selected. To find your comfort setting, start with the system in automatic mode by depressing the AUTO-PUSH knob. Adjust the comfort setting by using the red and blue buttons located below the digital display until you reach a value of 75 O (24"C), on the display. Give the vehicle F about 20 minutes to stabilize and then adjust the comfort setting if necessary, through theuse of the red and blue buttons. The display will showthe comfort setting for five seconds and thenit will show the outside temperature. In cold weather, the system will delay turning on the fan to avoid blowing cold air. The length of the delay depends on the engine coolant temperature and the outside temperature. Rotating the AUTO FAN knob will override this delay by turning off the automatic fan mode and changing the fan speed. . 7* 4 % - ... Your automatic electronic climate control system has two sun sensors located on the top of the instrument panel that detect direct sunlight. To keep you and your passengers comfortable, the system may supply cooler air to the side towards the sun. Be careful not to put anything over these sun sensors. The automatic electronic climate control system may not operate correctly if these sensors are covered. To change the automatic electronic climate control display from an English display to a Metric display, hold down the OFF button located inthe Driver Information Center for fiveseconds. The display in the Driver Information Center will also change from an English to a Metric display. To return to an English display, repeat the above procedure. 3-3