Zanussi ZW84PCBI User Manual - Page 6
Technical Data, Installation
![]() |
View all Zanussi ZW84PCBI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
7 Plate with rubber beater 8 Drain pump filter 9 Front feet for levelling the appliance 10 Drain hose A B Mod. xxxxxxxxx Prod.No. 910000000 00 C 000V ~ 00Hz 0000 W D 00A 00000000 11 Mains cable 12 Inlet hose connection 13 Back feet for levelling the appliance The rating plate reports the model name (A), product number (B), electrical ratings (C) and serial number (D). TECHNICAL DATA Dimension Width/ Height/ Total depth Electrical connection Voltage Overall power Fuse Frequency Level of protection against ingress of solid particles and moisture ensured by the protective cover, except where the low voltage equipment has no protection against moisture Water supply pressure 1) Minimum Maximum 59.6 cm /81.9 cm /55.3 cm 230-240 V 2100 W 13 A 50 Hz IPX4 0.5 bar (0.05 MPa) 10 bar (1.0 MPa) Water supply 2) Cold water Maximum Load Cotton 8.0 kg Spin Speed Maximum spin speed 1351 rpm 1) The appliance works correctly if the water pressure is not lower than 0.05 MPa (0.5 bar). If you cannot connect the water inlet hose to the cold water tap of the primary hydraulic system, connect it to your domestic cold water storage system. Make sure not to exceed a distance of 5.02 m (16.5 ft) between the appliance inlet hose and the bottom of the water storage tank. 2) Connect the water inlet hose to a water tap with a 3/4'' thread. INSTALLATION WARNING! Refer to Safety chapters. BE PREPARED FOR INSTALLATION It is recommended that installation is carried out by two persons. 6
![](/manual_guide/products/zanussi-zw84pcbi-user-manual-ca82378/6.png)