Whirlpool WRF535SMHZ Use & Care Guide - Page 19
Water is leaking from the dispenser system, Water from the dispenser is warm
![]() |
View all Whirlpool WRF535SMHZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
■ Reverse osmosis water filtration system connected to your cold water supply? This can decrease water pressure. See "Water Supply Requirements." Water is leaking from the dispenser system NOTE: One or two drops of water after dispensing is normal. ■ Glass not being held under the dispenser long enough? Hold the glass under the dispenser 2 to 3 seconds after releasing the dispenser lever. ■ New installation? Flush the water system. See "Water Dispenser." ■ Recently changed water filter? Flush the water system. See "Water Dispenser." ■ Water on the floor near the base grille? Make sure the water dispenser tube connections are fully tightened. See "Refrigerator Door(s) and Drawer." Water from the dispenser is warm NOTE: Water from the dispenser is only chilled to 50°F (10°C). ■ New installation? Allow 24 hours after installation for the water supply to cool completely. ■ Recently dispensed large amount of water? Allow 24 hours for water supply to cool completely. ■ Water not been recently dispensed? The first glass of water may not be cool. Discard the first glass of water. ■ Refrigerator connected to a cold water pipe? Make sure the refrigerator is connected to a cold water pipe. See "Water Supply Requirements." 19
![](/manual_guide/products/whirlpool-wrb322dmbb-use-care-guide-22004ba/19.png)