Weslo Lyne 3500 Uk Manual - Page 13
How To Use A Speed Program
View all Weslo Lyne 3500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
5. Measure your heart rate if desired. Before using the handgrip pulse sensor, remove the sheets of clear plastic from the metal contacts. In addition, make sure that your hands are clean. Metal Contacts To measure your heart rate, stand on the foot rails and hold the metal contacts-avoid moving your hands. When your pulse is detected, the small heart symbol in the lower right display will flash, one or two dashes will appear, and then your heart rate will be shown. For the most accurate heart rate reading, continue to hold the contacts for about 15 seconds. 6. When you are finished exercising, remove the key from the console. Step onto the foot rails, press the Stop button. Next, remove the key from the console and put it in a secure place. When you are finished using the treadmill, switch the reset/off circuit breaker to the "off" position and unplug the power cord. IMPORTANT: If you do not do this, the treadmill's electrical components may wear prematurely. HOW TO USE A SPEED PROGRAM 1. Insert the key into the console. See HOW TO TURN ON THE POWER on page 11. Each program consists of 30 one-minute segments. One speed setting is programmed for each segment. Note: The same speed setting may be programmed for two or more consecutive segments. The profiles on the left side of the Program Select button show how the speed of the walking belt will change during the programs. 3. Press the Start button or the Speed increase button to start the program. When either button is pressed, the treadmill will automatically adjust to the speed setting that is programmed for the first segment of the program. Hold the handrails and begin walking. When the first segment ends, a series of tones will sound. If a different speed setting is programmed for the second segment, the speed setting will flash in one of the displays to alert you, and then the speed of the walking belt will change. The program will continue until all 30 segments are completed. The walking belt will then slow to a stop. If the speed setting is too high or too low during the program, you can manually override the setting by pressing the Speed buttons. However, when the next segment begins, the speed of the walking belt will change if a different speed setting is programmed for the next segment. To stop the program, press the Stop button. The time will begin to flash in one of the displays. To restart the program, press the Start button or the Speed increase button. The walking belt will begin to move at 2 km/h. When the next segment begins, the speed of the walking belt will change if a different speed setting is programmed for the next segment. 2. Select one of the four speed programs. To select a speed program, press the Program Select button repeatedly; "P-1," "P-2," "P-3," or "P-4" will appear in the priority display for a few seconds to show which program is selected. The maximum speed setting of the selected program will also appear in one of the displays for a few seconds. 4. Follow your progress with the track and the three displays. See step 4 on page 12. 5. When you are finished exercising, remove the key from the console. See step 6 on this page. 60931EWT 60931LTEW 13